How To Properly Change The Oil In Your Citroën SM
Boy, this is how everyone should get the oil in their Citroëns changed. I think my SM is due. :0)
No related posts.
Related posts brought to you by Yet Another Related Posts Plugin.
No comments yet.
No trackbacks yet.
Did Your Citroen Traction Avant Fuel Gauge Stop Working?
about 1 month ago - No comments
Please advise how to access the fuel tank sending unit on a 1956 Citroën Traction 11BL. Either I have lost the electrical connection or the ground, or maybe the float has sunk to the bottom of the tank.
Jack Stands and Jacks – Where to Position Them on a Citroën
about 1 month ago - No comments
Question
This question came in recently, pertaining to the placement of jack stands and garage jacks under the car…
I just read your tip about getting under the car to check transmission worries, and you said to be sure to use jack stands.
1- where do I use my garage jack to lift the car? 2- where More >
CX Pulsing Brakes After Pad Replacement
about 1 month ago - No comments
Recently we have gotten several questions about Citroen CX brakes. Most often it is a case of the person replacing the pads on their front brakes, but not having replaced the rotors.
Finding That Part For Your Classic Citroen
about 2 months ago - No comments
Ever have a classic Citroen that you are working on and go into a modern day auto parts store looking for a set of spark plugs for it?
Bleeding Rear Brakes On Hydraulic Suspension Citroëns
about 3 months ago - No comments
How to properly bleed down the rear brakes on a Citroën with hydraulic suspension.
My 1987 Citroën CX Has Intermittent Hot Stall.
about 3 months ago - No comments
My car is an 1987 Citroën CX that has an intermittent stall when the engine is hot. It starts straight away from the ignition switch. It doesn’t happen all the time.
Removing A Citroën-D Series Door Handle
about 3 months ago - No comments
“I am at a loss as to how to access the outside rear door lift handle assembly for removal. While attempting to press out a small dent surrounding the outside door lift- handle using a lever through the window glass slot I dislodged one of the “bobby pin” shaped flat springs from the backside of the handle. So I not only need to replace that, I also still need to remove the handle to finish the dent removal. Any information will be sincerely appreciated.”
Lubricating The Rear Suspension Arm of the Citroën CX
about 4 months ago - 1 comment
The Citroën CX introduced in 1974 was the the replacement for the Citroën D Series. It was the last car that was designed by Citroën before Peugeot took them over. A wonderful riding and quite car, the CX was made through 1989 and was then replaced by the Citroën XM.
Fully Releasing The pressure on a Citroën Hydraulic System
about 4 months ago - 1 comment
One of the most common questions people ask about their high pressure Citroëns hydraulic systems is:
“How do I release the pressure on the hydraulic system to remove a sphere?” ” The last time I tried I carefully loosened the bleed screw on the regulator, but still got a hydraulic bath when I tried to remove a sphere”
Well there can often be more to releasing all the pressure on the Citroën hydraulic system then just opening up the bleed screw on the regulator, because there will still be residual pressure in the system even after that is done.
Checking the Bolts on the Citroën SM Gear Box
about 6 months ago - 2 comments
This is just a short reminder to all you Citroën SM lovers out there.
It is extremely important to get in the habit of checking and correcting, if necessary, the tightness of the bolts fastening the differential shaft extension housing to the Citroen SM gear box .
This should be checked after any repair involving removal of More >