Jack Stands and Jacks – Where to Position Them on a Citroën
Question
This question came in recently, pertaining to the placement of jack stands and garage jacks under the car…
I just read your tip about getting under the car to check transmission worries, and you said to be sure to use jack stands.
1- where do I use my garage jack to lift the car?
2- where do I set the jack stands?
My problem is changing the starter on a Citroën SM.
Citroen Tech Tip
To answer I thought I would put this short video together:
Because the person asked this question about an article I wrote about checking the Citroen SM clutch I will answer it for that car in particular. I will answer it with a non running car in mind.
Hope that helps.
Denis
No related posts.
Related posts brought to you by Yet Another Related Posts Plugin.
No comments yet.
No trackbacks yet.
Line up Those Timing Marks on Automatic Citroën SMs!
about 1 year ago - No comments
On the Citroen SM with 3.0 Liter Maserati engine and 3 speed automatic transmission, it is very important to remember this. If you remove the torque converter for repair, it’s possible when reattaching it to the engine to attach the torque converter to the crankshaft pulley in any one of four positions, only one of More >
Checking the Bolts on the Citroën SM Gear Box
about 2 years ago - 2 comments
This is just a short reminder to all you Citroën SM lovers out there. It is extremely important to get in the habit of checking and correcting, if necessary, the tightness of the bolts fastening the differential shaft extension housing to the Citroen SM gear box . This should be checked after any repair involving More >
How To Properly Change The Oil In Your Citroën SM
about 3 years ago - No comments
Boy, this is how everyone should get the oil in their Citroëns changed. I think my SM is due. :0) Share and Enjoy: These icons link to social bookmarking sites where readers can share and discover new web pages. No related posts. Related posts brought to you by Yet Another Related Posts Plugin.
Tensioning the Secondary Chains on Your Citroën SM With the Valve Covers Remaining on the Cylinder Heads
about 3 years ago - 3 comments
Would you like to know how to do that on your Citroën SM ? Tensioning the secondary chains with the valve covers remaining on the cylinder heads isn’t hard if you know the steps. It is imperative to bear in mind the grave risk of misaligning the camshafts , causing possible damage to the valves More >
How to Seal the Air Filter on a Citroën SM
about 3 years ago - No comments
On many Citroën SM’s, the front cover of the air filter assembly can be found distorted sufficiently to permit a partial volume of air to enter the carburetors directly, by-passing the air filter cartridge. It is possible to correct this by using a strip of foam rubber. To do this: Obtain a strip of foam More >