The Citroën CX introduced in 1974 was the the replacement for the Citroën D Series. It was the last car that was designed by Citroën before Peugeot took them over. A wonderful riding and quite car, the CX was made through 1989 and was then replaced by the Citroën XM.

Over the years working on the Citroën CX  one thing we found that needed attention was the rear suspension trailing arm bearings.Where the D Series car was equipped with very large tapered roller bearings for this function, the CX had light weight, (by comparison) needle bearings.

What would happen over time is these bearings would start to wear and begin to freeze up. This would cause the rear axle not to move up and down freely, and in extreme cases the axle would start to dislocate and cause the alignment to change with extreme tire wear being the result.

That amounted to quite a problem. You see these axles when they are worn in this manner can be very hard to remove and replace the worn out bearing. So what we started to do when a Citroën CX would come into the shop that had rear axle bearings still in good shape was a bit of preventative maintenance in the form of greasing the bearings.

Now to you died-in-the-wool Citroën CX people out there this might sound a bit extreme, but it sure worked for us. This was to locate a spot that was accessible on the bottom of the axle housing where the bearing is housed. (see arrow on parts drawing) Here we would drill and tap a hole into the hollow portion of the housing to accommodate a grease fitting. (As a side note when doing something like this you want to apply some grease to both the drill bit and the tap so that the chips and the filings you make will stick to the grease and not go into the housing).

Once this is done and the grease fitting is threaded in you can apply some grease into your Citroën CX axle bearing housing with your grease gun. You will find that the housing will take a fair amount of grease to fill it up, but use your better judgment and do not pump too much grease into the bearing housing and blow out or damage the bearings .You will know when you start to get a bit of resistance to the grease gun.  After this a pump or two at each service should keep the bearing in good shape.

Another option is to try and get higher up on the housing and then get some gear oil into the housing. You will want to have a plug to plug up the hole after you do this. Either way will get some lubrication into the bearings and that is what you want to do.

Good luck and always remember to wear some eye protection when you are drilling into this material. The use of a variable speed drill will also give you much better control of what you are doing with this project. Stay safe.

No related posts.